Spray
SIL-LUB 134
MOLY DRY FILM LUBRICANT
PRODUCT DESCRIPTION
SIL-LUB 134 Moly Dry Film provides a thin, quick dry coating of
Molybdenum Di-sulphide which held on the surface with a blend of
Organic and inorganic binders. When applied to clean metal all metal
pores, valley, scratches and other microscopic recesses in the surface
are filled. After surface are loaded, the Moly takes on a compacted
nature in the recesses ands serves to greatly reduce friction under
loading condition. Contains No Oil or Grease.
Excellent for a pre-lubrication coating on high temperature mechanisms,
as an assembly lubricant, as a press fit tube and many other metal
high pressure point uses.
USE ON:
Casting moulds, Oven hardware, Cans, followers, Rollers, Chains
Cable, Open Gears, Threaded Fasteners, Slides, Latches, Locks, Pins,
Bearings, Press fits, as a break-in lube on bearing and for many
other application.
DIRECTION FOR USE:
Shake can well before use Can temperature should be 65°F or
warmer. Never use direct heat to warm aerosol cans. Only warm water
should be used. Clean metal surface before application and spray
area to be lubricated. Permit to dry for a few minutes before use.
| TYPICAL SPECIFICATION: |
| Lubrication, load capacity, psi 140,000 |
| Colour Dark Gray |
| Minimum functional Limits |
| Air Exposure, °F -250°F |
| Maximum Functional Limits |
| Oxygen Free Environment, °F 2,000 |
| Air Exposure, °F 750 |
| Residue from Binder @High Temperatures Soft Dust |
| Particle Size Dispersion Grade |
